Dial in any value from 8 Decades Resistors, Capacitors & Inductors.
R, L, C isolated or any possible RC, LC, RL, RLC combinations
by Roger Leifert
I have a slight preference for the elliptical layout, but either layout will be fine.
Looking at it, I am confused about the upper/lower vs high/low change. It is for range selection, but to my non-native speaking ears upper/lower can also refer to physical position. In practice either will probably be fine as you get used to how it works.
Rodger I prefer the prototype layout but I could live with either one.
Hard to say but I do think I have a slight preference for the prototype design. Readibility should be good either way.
I prefer the prototype's layout. Looks like you're trending to a nearly evenly split vote on this!
I really prefer the prototype's layout for dial values.
@Lothar I believe that the white on black is the design program and not representative of what the screen printing would look like
do you really intend to have a black background with a white font?
IMHO I would prefer black vont on white background.
I like the way you placed the connectors on the new design, but the font is a little squeezed
Maybe you place the logos below the connectors left and right?
The prototype design shows at each switch position the complete unit at least once . So i prefer the prototype design.
Thank you for the update. I prefer the elliptical arrangement. To my eyes, it is easier to read.