I posted a new release (r238) on ubertooth.sourceforge.net this week. Highlights include:
- assembly diagrams to make building hardware easier,
- UAP discovery in the Kismet plugin, and
- specan_ui.py, a new real-time spectrum analysis application.
If you haven't seen it yet, you should check out the demo video that Jared put together for the spectrum analyzer (which he wrote):
Also, there is a new "getting started" page that I suggest everyone read:
seconds to go
Pledge $15 or moreYou selected
and receive an Ubertooth One printed circuit board that you can use to build your own Ubertooth One or keep as a souvenir. You will also receive a single-use laser-cut stencil to make the assembly process easier.
Pledge $30 or moreYou selected
and receive a printed circuit board and stencil for building your own Ubertooth One. In addition, you'll receive a fully assembled and tested pogoprog, a serial programming device that you can use to load firmware onto your Ubertooth One.
Pledge $100 or moreYou selected
and receive fully a assembled and tested Ubertooth One.
Pledge $180 or moreYou selected
and receive two assembled and tested Ubertooth Ones.
Pledge $220 or moreYou selected
50 backers All gone!
and receive one assembled and tested Ubertooth One plus one special Kickstarter Edition Ubertooth One featuring the LPC1759 processor, an enclosure, and a special antenna.
Pledge $221 or moreYou selected
15 backers All gone!
and receive one assembled and tested Ubertooth One plus one special Kickstarter Edition Ubertooth One featuring the LPC1759 processor, an enclosure, and a special antenna. This is the same as the $220 reward, but I was able to open up a few more slots.
- (30 days)