Hello FLEKS users, just wanted to let you know that we updated our instruction guides for our different plate models on the website! https://www.fleks3d.com/standardsimple/
Support and Assemblage
Hello backers! As a reminder, if you have any questions about assembling your plate, or about the materials that should be used for an optimum printing experience, please see our... Read more
Hello backers! We have started the process of shipping. Right now, we are shipping as we receive plates that have completed production, which means that some of you might receive... Read more
Production in Last Stages!
Hello again backers! Tomorrow will be the LAST day to update your shipping information, or take advantage of our prices on Kickstarter. Production is in its final stage, and we... Read more
Hello backers! Production is well underway! We would just like to give some backers a few more days to necessarily update their shipping addresses. Any backer who has received a... Read more
Locking down orders!
Hello again backers! Production is in full swing, we are still on target to start delivery in July. Our discounted prices available on Kickstarter will available through the end of... Read more
Good news backers! Production is underway and almost complete. We will begin shipping out select models in the coming week. All models will be cut and shipped out by the... Read more
Production Status and Backer Surveys
We are off the races.
We had a little hiccup with one of the suppliers but we think we have it all solved and will kick-off production next... Read more
SURVEYS ARE OUT!
Please check you email inbox's for your Backer Survey coming in from BackerKit. Please fill out quickly so we can process and get your order into our system. ... Read more
SURVEYS GOING OUT THIS WEEK!
We are working on the Survey's with Backerkit today and tomorrow. Be on the look out for the Survey's this week.
Please make sure your Credit Card is... Read more
WE MADE IT!
Once again thank you all. I can not say how fortunate we are to have the support of you all.
In the following weeks we will be sending... Read more
We have 3 days left on the campaign!
THANK YOU BACKERS!
We are Fully Funded with 3 days left! We could not have done this with out you.
Please for the next couple days keep sharing with your... Read more
Surveys and Extra Plates
We have had a few questions about Surveys and Extra Plates.
Surveys will go out at the end of the campaign through Backerkit. This will help organize all... Read more
13 days left and we are soooooo close!
Hello Backers, 3Dprinters and Makers!
Once again thank you for backing FLEKS3D Build Plate. We can not make this possible without you.
We are so happy with the results of... Read more
First off, thank you backers, your support is awesome!
We are halfway there in funding and closer than ever to bringing you FLEKS3D!
Please continue to share and help us... Read more
We would like to thank you for your continuing support for FLEKS3D!
Over the past 3 years, we have dedicated ourselves to innovating better, more accessible Build-Plates for... Read more
frame thickness and 12x12 inch in Mm.
- Frames are .5 in wide. 1 in in total. This area is not printable and will subtract from the printing area.
- The 12 X 12 inches is 304.8x304.8mm.... Read more