Share this project

Done

Share this project

Done
Please help us take DIY 3D Printing to the next level, support this open source photo-initiated polymer resin based 3D printing system!
Please help us take DIY 3D Printing to the next level, support this open source photo-initiated polymer resin based 3D printing system!
388 backers pledged $513,422 to help bring this project to life.

Hardware Kits!

Our hardware vendor has delivered 10 sample kits for our review.

All hardware (nuts, bolts, etc.) required to build the B9Creator is pre-sorted and packaged to make it easy to locate the correct small parts during assembly

We break the hardware into five "Assemblies":

1.  XA:  The x-axis (sliding vat) assembly

2.  ZA-A:  The z-axis support assembly

3.  ZA-B:  The z-axis build table assembly

4.  PS:  The projector support structure assembly

5.  FA:  The final assembly.

Everything looks good so far, we will be verifying the contents when we build the first ten B9Creator's over the next few weeks.  This will allow us to "tweak" the contents and organization if needed. 

Comments

    1. Creator Michael Joyce on May 22, 2012

      Graham Great idea, but ... we already did that!
      http://www.flickr.com/photos/b9creator/7147876159/

    2. Creator Graham Stabler on May 22, 2012

      I had a look through all of the photos and it really looks great. I have only one possible improvement, I think you should laser cut the labels for the jog switches into the sheet! :)

    3. Creator Michael Joyce on May 21, 2012

      For clearer photos of the bagged parts see: http://b9creator.com/index.php/gallery/

    4. Creator Graham Stabler on May 21, 2012

      IKEA 0, B9Creations 1