Pico - The First 48 Hours
Backers, Printers, and Friends,
Since the launch of Pico's campaign on Monday night, we have been continuously astounded by the support you've shown through your kinds words and contributions. As of this writing we are approximately $1,000 away from reaching our initial goal, bringing us critically closer to enhancing your RepRap 3D printing through Pico. We've even been so fortunate as to be featured on 3ders.org, less than 24 hours after launch. Check out the article and share some of your kindness with the individuals behind this community.
We've experienced a number of emotions throughout the development of Pico and through the Kickstarter launch, but currently there is one simple word to describe our current emotional state—Humbled.
Thank you for the tremendous support thus far. We're committed to enhancing your 3D printing experience and further contributing to the RepRap family.
That being said, we would love to offer STRETCH GOALS if we reach $25,000 and $50,000. Considering the open nature of our RepRap community, we would LOVE to hear your suggestions and know what more we can do to take our campaign to another level.
Nobody knows what YOU want better than you, so please... share in the comments section and we will evaluate adding YOUR suggestions to our continuously evolving innovations.
Please continue to share with your peers and make our growing RepRap community richer through collaboration—Print on, Printers.
Will & Mike