Share this project

Done

Share this project

Done
Hexy the Hexapod - Low-Cost Six-Legged Open Robot's video poster
Play

Robotic Hexapod kit. Cute, cheap, easy and fun intro to advanced robots. Arduino-powered, and all Open Hardware/Software. Read more

Boston, MA Robots
Share this project
861
backers
$168,267
pledged of $13,000 goal
0
seconds to go

Funded!

This project was successfully funded on June 27, 2012.

Robotic Hexapod kit. Cute, cheap, easy and fun intro to advanced robots. Arduino-powered, and all Open Hardware/Software.

Boston, MA Robots
Share this project

Shipping starting next week!

The first boards have shipped from China as of yesterday, and should be arriving next week! Short and customs issues or board defects, with those, we can start the mass shipments to kickstarter folks. Looking forward to getting out all those kits! Keep in mind the whole cutting and shipping process is projected to take the better part of November, and should finish up by early December. International shipping is typically 2-3 weeks for Europe, 3-5 weeks for other countries. We'll be sending you an email when we ship your unit. Almost there!

At the same time as the boards are arriving, the new laser cutters have arrived! These should be running Monday when the manufacturer comes to install the glass laser tubes:

Also, surveys have been sent out to those who bought the model rewards. Here are the pictures to choose your kit. They'll be the first things we start cutting with the new cutters, as you guys have been waiting much longer than you should have.

Full resolution versions of all the pictures are available in our flickr stream:

http://www.flickr.com/photos/arcbotics/sets/72157631914254275/

Comments

    1. Creator ArcBotics on November 6, 2012

      We get our lasers from Rabbit Laser USA. These are our 2nd and 3rd from them.

    2. Creator Ryan Blackwood on November 5, 2012

      Sorry, I was asking which model you're using.
      Thanks

    3. Creator Pasha on November 3, 2012

      yeay!!

    4. Creator Ryan Blackwood on November 3, 2012

      Which laser cutters are you suing?