Share this project

Done

Share this project

Done
ZATSIT is a kit to build a delta robot and 3D printer, innovative in its technology, architecture, construction and performance.
ZATSIT is a kit to build a delta robot and 3D printer, innovative in its technology, architecture, construction and performance.
174 backers pledged €43,033 to help bring this project to life.

Some Zatsit's Tricks

6 likes

Hello friends, dear backers! 

In the video I am publishing today below, I show some tips related to the attachment system of the accessories, by three magnets. 

One of these tips concerns the creation of a hot chamber, to print certain difficult plastics in a heated environment (up to 130°C, if the power of the heating bed is sufficient). 

This feature is usually reserved for professional printers, very expensive, and is obtained by sophisticated technical means, protected by a thick patent mat. Zatsit makes this feature available to you in ridiculously simple ways, and offers it in Open Source to all 3D printing enthusiasts. 

 As you may have noticed, I like simple and elegant solutions. 

Admittedly, the printing volume is considerably reduced: Ø100 x 40mm, in the simplest version shown here. The height can be doubled or tripled by replacing the crown component with a telescopic version. But even with such a small volume, believe me, it's very useful! In particular, gears can be printed, in Nylon, POM, etc... 

I hope this video will interest the whole 3D printing world, and it is also intended to make Zatsit famous. Feel free to share!

Comments

Only backers can post comments. Log In