Getting Started Video with Christopher Walken
We are releasing an informative new video today. It illustrates the best practices for setting up the Pulse Sensor as a Finger Strap or Ear Clip, and thus getting... Read more
Pulse Sensor at TEDx Kids in Brussels
Tito Jankowski [ of fellow Kickstarter Project OpenPCR ] used the Pulse Sensor in a workshop and talk for TEDx Kids in Brussels. The openingof the below segment shows... Read more
Pulse Sensor Amped released, thanks to you Job Creators!
You can now, without any sarcasm, refer to yourselves as "Job Creators". Because of your early backing we've started an LLC in New York, World Famous... Read more
Pulse Sensor in Current Make Magazine, Cool Stuff
The good folks at Make Magazine asked us to write a detailed article about the Pulse Sensor for vol. 29 (on newsstands now). The "DIY SuperHuman" issue is all... Read more
Significant Code Update, Verison 0.6, Up Now!
There is a new version of Pulse Sensor code now up on our Code Downloads page! The new version (version 0.6) is a significant update and we advise everyone to... Read more
All International Shipments Have Gone Out
Hi Dear Backers,
We are in the home-stretch of getting all your rewards out. Last week we shipped out all the remaining International-bound Pulse Sensors. If you are outside... Read more
Second round of shipments, and other recent FAQ's
We are still getting emails about when the second round of shipping will take place. We posted in the "comments" area about this. But to review, the second... Read more
We Did It!
Thank you for backing us. The kickstarter campaign was so much more successful then we ever thought, thanks to all of you. We have been working hard to... Read more
We got a couple more photos of the Pulse Sensor made.
Front Side of Pulse Sensor
Back Side of Pulse Sensor
Ear-clip, hot-glued onto the back of sensor.
Out and About in the World
The Pulse Sensor has been getting out and about in the world.
Two weeks ago we were interviewed for an MTV Brazil show called Mod. It will air in the fall... Read more
Thank you again for your amazing support and interest.
We have been busy getting Pulse Sensor production prototypes ready. In this update, we are very proud to show-off... Read more
Pulse Sensor Functionality & Software Tour
We're super excited to be able to bring the Pulse Sensor to life! We have been working with a manufacturer to produce the Pulse Sensor, and will have... Read more
Funding Goal Break Through ++
We just broke through our funding goal! We are stunned at the response and invigorated by our backers collective awesomeness! This is going to happen! With your pledges... Read more