Padded camera compartment with re-configurable dividers: 3.75” deep x 11.5” long (at the longest point) x 6.5” wide (at the widest point)
It’s important to note that the panel dividing the camera portion and the upper daypack portion is specially designed to flex upward, allowing items taller than 3.75” to fit, while still providing protective padding.
This allows it to accommodate DSLRs up to the size of the Canon 6DMkII. It is ideally sized for mirrorless cameras and drones.
Main Gear Compartment: 21" x 12.5" x 5.25"
The side access door will admit cameras as tall as the Canon 5D with lens attached. Most DSLRs with battery grips attached will not fit through the side door.
Taller cameras such as the 1Dx will not fit in an upright position, but fit well when laid flat without a lens.
Depending on how you pack the facing wall with the tablet compartment and mesh organizer pockets, you may be able to fit items that are taller than the 5.25” height of the sidewalls. Also, the wall between the clothing compartment and gear compartment has a bit of flex, so load the gear side first if you want to maximize the usable space on that side.
The main external fabric is N900D square ripstop with 0.20mm film-laminated TPU65 coating. Extremely durable and water resistant.
The bottom section of the cube pack uses that same material, and the top collapsing section is N420D with 5PM coating.
We’ve used high strength nylon webbing, durable urethane coated zippers, hypalon lash points and reinforcements, and a compression-molded EVA back panel. The harness is designed to stay comfortable even under heavy loads with dual-density EVA and PE foam padding and high grade air-mesh. The harness is linked to the aluminum stays in the frame sheet via the load-lifter straps. When worn with the hip belt, this system transfers some of the load off of your shoulders, on to your hips for a more comfortable and efficient carry.
Interior materials include Velux hook-and-loop compatible fabric which holds up under intense cycle testing. We quilted it to the underlying layers of padding to make sure it never pulls away from the walls or floor. Elsewhere we’ve used high-density nylon 210D liner fabric and mesh.