RefloLeo is an integrated toaster oven controller that is designed for the hobbyist or electronics designer who needs to create a small quantity of electronics with surface mount components. This is perfect for prototyping work or small volume production with professional look and performance. This oven controller will regulate the internal temperature of the oven according to a set heating profile that best suits the components being baked. This makes it super easy to reliably bake your own PCB designs at home. Just put your board that is ready to bake in the oven, turn on RefloLeo, select your desired baking profile and wait just a few minutes for RefloLeo to bake your board for you. After a short cool down time, you are ready to remove your completed board from the oven that is ready for use in your project. RefloLeo takes care of the multi-stage timing, pre-heating, heat soaking, peaking and cool down for you.
- K-type thermocouple
- Arduino Leonardo compatible
- Simple setup and operation
- USB powered
- 5V, 600mA external relay control capability
- Open hardware design
This design avoids the major surgery involved in most toaster oven conversions for PCB reflow work by not requiring the owner to disassemble and change the internal workings of the oven. You simply plug the oven into the external relay controller and RefloLeo turns the oven on and off according to the programmed heating profile. If you either live in another country where power requirements differ or simply choose to supply your own power relay, RefloLeo can control an external relay with up to 600 milliamps at 5 volts through its integrated MOSFET on the relay control terminals.
RefloLeo is simple and friendly to program. It is Arduino compatible by emulating an Arduino Leonardo and can be programmed just as easily. The firmware that comes with RefloLeo is available for free, including the source code, and you can program additional features easily if you would like. Uploading your own custom firmware is easy by using the Arduino integrated development environment and uploading the new firmware over USB. It is easy for the beginner but has advanced options available too. This is a fully integrated design that does not require an external Arduino circuit board to operate.
Reflow profiles are stored as text files using the simple instruction set and saved on a standard SD memory card. RefloLeo will read from this text file and execute its instructions to follow the profile you have specified. Up to 255 different reflow profiles can be saved, selected from the on-screen menu and used to accommodate any job.
Example low temperature reflow profile:
T130,000 Goto 130 degrees
W000,015 Wait 15 seconds (and turn off heat)
H150,120 Hold at 150 degrees for 120 seconds
T212,000 Goto 212 degrees
W000,020 Wait 20 seconds (and turn off heat)
H225,020 Hold at 225 degrees for 20 seconds
X000,000 Exit program and turn off relay
RefloLeo can be used with a variety of toaster ovens or hot plates. Please be sure to closely monitor your oven or hot plate during baking to be sure of safe operation.
Risiken und Herausforderungen
This project carries minimal risk and challenges. All of the components required to make RefloLeo can be sourced from multiple vendors within the United States. Since I already have my own RefloLeo that works great, I'm setup for small production runs like this. Should this become a super popular project and become a larger job than a small production, I will engage the services of an external circuit board assembly house to meet production demands.Näheres zur Rechenschaftspflicht auf Kickstarter
- (30 Tage)