We've launched an exciting new project of our own! Introducing the Kickstarter app for iPhone!

Funded! This project successfully raised its funding goal on February 28, 2011.

Photo-main

Ubertooth One is an open source 2.4 GHz wireless development platform that can be used for Bluetooth sniffing and more.

Thanks for visiting Ubertooth One on Kickstarter! I'm Michael Ossmann, and I hope you'll help me launch the world's first affordable Bluetooth monitoring and development platform. This is a fully open source product (both hardware and software) that I've been working on for about two years. It is finally ready to release, but I need your help to produce a run of fully assembled and tested units, making the platform accessible to all.

Commercial Bluetooth monitoring equipment starts at about $10,000. Project Ubertooth seeks to produce an affordable platform that can be used for Bluetooth monitoring and for the development of new Bluetooth and wireless technologies.

Low-cost off-the-shelf Wi-Fi adapters have supported monitor mode for years, and the technique has found diverse uses in security research, troubleshooting, product development, intrusion detection, and more. Unfortunately, there has never been an equivalent tool for Bluetooth before Ubertooth One, a fully open source platform (both hardware and software).

You can find out more about Project Ubertooth on my blog and at the project web site.

Thank you for taking the time to check out Ubertooth One! It is people like you who will make this project a success by pledging your support or just spreading the word.

Thanks to Dan Gottesman for editing my Kickstarter video on very short notice. Thanks to the Baldwin Brothers for their song Right On.

FAQ

Have a question? If the info above doesn't help, you can ask the project creator directly.

Ask a question
441
Backers
$53,001
pledged of $16,384 goal
0
seconds to go

Funding period
Jan 29, 2011 - Feb 28, 2011 (30 days)

Mike-and-milo.medium

See full bio

  • Pledge $15 or more

    12 backers

    and receive an Ubertooth One printed circuit board that you can use to build your own Ubertooth One or keep as a souvenir. You will also receive a single-use laser-cut stencil to make the assembly process easier.

  • Pledge $30 or more

    50 backers

    and receive a printed circuit board and stencil for building your own Ubertooth One. In addition, you'll receive a fully assembled and tested pogoprog, a serial programming device that you can use to load firmware onto your Ubertooth One.

  • Pledge $100 or more

    234 backers

    and receive fully a assembled and tested Ubertooth One.

  • Pledge $180 or more

    68 backers

    and receive two assembled and tested Ubertooth Ones.

  • Pledge $220 or more

    50 backers All gone!

    and receive one assembled and tested Ubertooth One plus one special Kickstarter Edition Ubertooth One featuring the LPC1759 processor, an enclosure, and a special antenna.

  • Pledge $221 or more

    15 backers All gone!

    and receive one assembled and tested Ubertooth One plus one special Kickstarter Edition Ubertooth One featuring the LPC1759 processor, an enclosure, and a special antenna. This is the same as the $220 reward, but I was able to open up a few more slots.